Heavy Duty rear propeller shaft for Toyota Kzj70, produced in Italy by a specialized company.
This particular shaft has the closed length identical to the original shafts but has the possibility to stretch up to 5 cm more than the original, so it is ideal on trims from +5cm to +10cm.
These shafts are balanced at 2800 rpm and are built using high quality joints and u-joints.
This particular shaft, designed to eliminate any vibration and any danger of breaking, is constructed by making the following improvements to the serial shafts:
- giunto Slide with grease, the magiorato diameter than the original;
- ideal for raised setups, it avoids the insertion of extensions by canceling all forms of vibration;
- increased universal joint DANA SPICER of standardized dimensions, and can be purchased from any spare parts dealer, equipped with grease nipple, with a working angle of 10° higher than the original;
- flange Forged high quality which allow an inclination of cruises up to 35° enable the use with raised structures.
- pipe Increased diameter, 60mm against 50mm of original, carefully balanced to avoid any form of vibration;
- joint up to 10 cm with shrinking metal protection treaty with Rilsan with o-ring protection, allows a protective slide from damage caused by stones, sand and the like and protects the slide from dirt.
