Heavy Duty front propeller shaft for Toyota Kzj70, produced in Italy by a specialized company.
This particular shaft has the closed length identical to the original shaft but has the possibility to stretch up to 5 cm more than the original, so it is ideal on trims from + 5cm to + 10cm.
These shaft are balanced at 2800 rpm and are built using high quality joints and ujoints.
This particular transmission shaft, designed to eliminate any vibration and any danger of breaking, is constructed by making the following improvements to the serial shafts:
- sliding joint with grease nipple, with a larger diameter than the original;
- ideal for raised setups, it avoids the insertion of extensions by canceling all forms of vibration;
- increased ujoint DANA SPICER of standardized dimensions, and can be purchased from any spare parts dealer, equipped with grease nipple, with a working angle of 10° greater than all Original;
- flanges forged high quality which allow an inclination of cruises up to 35° enable the use with raised structures.
- pipe Increased diameter, 60mm against 50mm of original, carefully balanced to avoid any form of vibration;
- joint up to 10 cm with shrinking metal protection treaty with Rilsan with o-ring protection, allows a protective slide from damage caused by stones, sand and the like and protects the slide from dirt.
