These reinforced front radius arm, which are indispensable on raised structures, replace the original control arm of the Land Rover Defender without any modification, are available in different versions to adapt to all vehicles of any year and model.
Made in Italy with C45 steel, they are accurately welded with TIG technology, fully galvanized and coated with polyester powder with anti-scratch treatment.
These radius arm advance the axle of 2cm, so as to restore the correct pitch on raised 10cm structures and advance it about 1cm on raised stretches of 5cm. The consequence is the improvement of stability thanks to the extended wheelbase and an obvious improvement of the exit angle, since the upper spring support and the upper attachment of the shock absorbers remain unchanged, while the lower attachments move together with the pont. If you use elongated spring-loaded cones and shock-absorbers with a larger body to avoid interference, use the backward spring plates.
The caster angle was corrected to compensate for the bridge rotation caused by the rise. This correction allows the transmission shaft and especially the steering linkage to work with the correct angles;
From the drop down menu at the top you can choose the model suitable for your vehicle.
