Polyurethane bushings control arm Suzuki Jimny from 2018 chassis side.
The kit replaces all the frame-side bushings of 2 radius arm both rear and front and can be installed both with original radius arm and with aftermarket radius arm
This innovative type of highly resilient silentblock with alveolar structure, gives a high capacity of deformation while preserving unchanged the bush structure, the air pockets imprisoned inside the same bush help to isolate the radius arm from the frame giving a comfort that no other type of bushings can give at the same time increasing the mobility of any type of trim.
The honeycomb structure has been obtained by removing some material in some areas where the bush is not stressed, creating small arches that support the double wall of each single bush, this has allowed the use of the finest material while maintaining the low price.
The kit is produced in Italy with polyurethane produced by the renowned API company, compared to the original rubber bushings or the classic polyurethane, the honeycombs are more resistant and contribute to increase the softness of the trim and the stability of the vehicle, both with original trim that raised.
The high quality of the material used and designed specifically for this use makes these bushings very long-lasting over time even with heavy use of the vehicle and with high performance trims.
This kit consisting:
- 4 bushes in high quality polyurethane with honeycomb structure;
- 2 bushings in galvanized C45 steel.
Assembly: being made up of 3 separate pieces assembly is easier than the bushings built in one piece like the originals.
Other necessary changes: none.
