Toyota 70 series ring and pinion set
Reinforced rear ring and pinion set 8", low ring, standard rotation (Rear differential).
The pinion and the ring are machined from solid with CNC machines, with thermal treatment of anti-wear cementation, very silent, totally Italian production.
IMPORTANT: If you have a Toyota LJ70 square headlight model you must buy the bevel gear pair for the KZJ70.
Specifications 4.88 ratio
- rear axle
- pinion spline 27
- ratio 4.88
- ring gear bolts 10
- ring gear outer diameter 204mm
- standard rotation
- number of teeth: 39/8
Specifications 5.38 ratio
- rear axle
- pinion spline 27
- ratio 5.38
- ring gear outer diameter 204mm
- standard rotation
- number of teeth: 43/8
IMPORTANT. Replacement of a ring and pinion set is a job that requires professionalism, an installer can only perform it with suitable equipment and with the proper knowledge of its calibration. Incorrect assembly causes breakage or early use of the same.
