Heavy Duty transmission shaft produced in Italy by a specialized company that can be installed on all Toyota LJ70 made to measure according to your needs.
This particular drive shaft stretches up to 10 cm, therefore it is ideal on raised structures or with an elongated wheelbase.
These shafts are balanced 2800 RPM and use high quality DANA SPICER u-joints.
As this is a made-to-measure shaft, it is specified that it is not ready for delivery but that it must be produced after ordering with advance payment. Delivery times will be estimated only after the purchase of the customized tree type.
From the top menu you can choose the HD shaft model and length.
The photos are indicative only.
This particular shaft, designed to eliminate any vibration and any danger of breaking, is built by making the following improvements to the standard shafts:
- sliding joint with grease nipple, with a larger diameter than the original;
- ideal for raised structures, avoids the insertion of extensions, eliminating any form of vibration;
- oversized cruises with normalized dimensions, which can therefore be purchased from any spare parts dealer, equipped with grease nipples, with a working angle of 10° higher than the original;
- high quality forged flanges that allow an inclination of the cruises up to 30° allowing them to be used even with raised structures;
- tube with an increased diameter, 60mm against the 50mm of the original, carefully balanced to avoid any form of vibration;
- sliding up to 12 cm with protective metal fitting covered in RILSAN with protective o-ring, it allows to have a protection of the slide from damage caused by stones, sand and the like and protects the slide from dirt.
IMPORTANT. For shafts over 780 mm in length, the price is estimated on request.
