Toyota KZJ70/73 ring and pinion
Reinforced rear 8” ring and pinion set, high ring, standard rotation (Rear differential).
Pinion and ring are CNC machined from billet, with anti-wear case-hardening heat treatment, very quiet, totally Italian made.
Specifications 4.88 ratio
- rear axle
- pinion spline 27
- ratio 4.88
- ring gear outer diameter 204mm
- standard rotation
- number of teeth: 39/8
Specifications 5.38 ratio
- rear axle
- pinion spline 27
- ratio 5.38
- ring gear outer diameter 204mm
- standard rotation
- number of teeth: 43/8
Important: The replacement of a bevel gear is a job that requires professionalism, an installer can perform it only with appropriate equipment and with due knowledge of its calibration. Incorrect installation causes breakage or premature wear of the same.
