Rear propeller shaft Heavy Duty for Toyota KZJ70 with 1 double joint, MADE IN ITALY by a specialized company.
This particular shaft has a closed length identical to the original shafts but has the possibility to stretch up to 5 cm in more original, is therefore ideal of assets by + 5cm of + 10cm.
This particular shaft, designed to eliminate any vibration and any danger of breaking, is constructed by making the following improvements to the serial shafts.
These shafts are balanced at 2800 rpm and are built using high quality joints and universal joints not agricultural components as most of the products in circulation.
This particular shaft, designed to eliminate any vibration and any danger of breakage, is made by making the following improvements to the standard shafts:
- sliding joint with grease nipple, with larger diameter than the original;
- ideal for raised structures, avoids the insertion of extensions, eliminating any form of vibration;
- DANA SPICER oversize universal joints of standardized dimensions, which can therefore be purchased from every spare part dealer, fitted with grease nipple, with a working angle of 10 ° above the original;
- high quality forged flanges that allow an inclination of the crosspieces up to 35 ° allowing their use even with raised structures.
- tube of increased diameter, 60mm against the 50mm of the original, carefully balanced to avoid any form of vibration;
- sliding up to 10 cm with protective metal fitting TREATED WITH RILSAN with protective o-ring, it allows to have a slide protection from damage caused by stones, sand and the like and protects the slide from dirt.
