Rear reinforced transmission shaft produced in Italy by a specialized company.
This particular shaft, designed to eliminate any vibration and any danger of breakage, is built by making the following improvements to the standard shafts
These shafts are balanced at 2800 rpm and are built using high quality joints and crosses and not agricultural components like most of the products in circulation.
This particular shaft, designed to eliminate any vibration and any danger of breakage, is built by making the following improvements to the standard shafts:
- increased universal joints and normalized sizes, that can be purchased from each spare parts, equipped with a 90° grease nipple, with a working angle of 5° higher than the original;
- reinforced sliding joint and with threaded end-stop flange that does not allow the ribs to come out of the seam even with very raised set-ups;
- high quality forged flanges that allow an inclination of the cruises superior to the standard shafts allowing their use even with raised structures.
This shaft has both flanges with 4x8mm holes and 45mm SAE45 centering.
