Heavy Duty transmission shaft produced in Italy by a specialized company specifically for Suzuki SJ410.
This particular shaft has the length from closed identical to the original shafts but has the ability to stretch up to 5 cm more than the original, it is ideal then on assets over + 5cm or trim with shackle reverse.
These shafts are balanced at 2800 rpm and use high quality DANA SPICER u-joints, not rural components as much of the economic products.
This particular drive shaft, designed to eliminate any vibration and any danger of breakage, is built by making the following improvements to the standard drive shafts:
- sliding joint with grease nipple, with a larger diameter than the original;
- ideal for raised structures, avoids the insertion of the extensions eliminating any form of vibration;
- increased u-joints of normalized dimensions, which can therefore be purchased by each spare parts, equipped with grease nipple, with a working angle of 10 ° greater than the original;
- high quality forged flanges that allow the inclination of the cruises up to 35° allowing their use even with raised structures;
- tube with increased diameter, 60mm against the 50mm of the original, carefully balanced to prevent any form of vibration;
- sliding up to 10 cm with metal protection cover coated with RILSAN with O-ring protection, allows you to have protection of the slide from damage caused by stones, sand and the like and keeps the slide from dirt.
The flanges have 4 holes of 8mm and the centering of 42mm.
