Repositioning dampers bar Rear shock absorber repositioning bar that allows: to reinforce the upper attachments of the rear shock absorbers; To reposition the shock absorbers so as to make full use of their travel; to adapt the shock absorbers to any type of setup. The bar has threaded attachments to which the shock absorbers are fastened by means of pins and is complete with stainless steel pins and washers, self-locking safety nut and aluminum spacers.It is made in Italy from C45 steel that has been surface-treated with anti-corrosion tropicalization and allows the shock absorbers to be mounted in 5 different positions: a neutral position that is needed in case you need to tilt the shock absorbers to make room for other accessories, such as exhaust, nitrogen tanks, etc; two positions that allow the couplings to be moved 15 mm and 40 mm apart, respectively, so that long shock absorbers can be installed without over-thickening the end pads; two positions that allow the shock absorber mounts to be moved closer by -5 mm and -30 mm, respectively, so that original shock absorbers can be installed even on raised setups. The position of the attachments is engraved on the bar.
